Structure

These are a few pictures from the initial structure I built for Theta Waves. It is approximately 8x10 feet. There were a few problems I ran into during this process. I decided to cut all of the pieces of wood in half to make it easier to transport from place to place and I also made it a bit smaller than planned because it was difficult to fit even in my house. Also, I had to make a small alteration to its width because the fabric I bought to cover its surface was too small. Otherwise it seems to look good and it is sturdy. I've posted the pictures taken of the wood, brackets, building process, labeling and final piece in a zip file.


Final frame


Brackets


Support stand

For all photos download the zip file below:
http://www.imagearts.ryerson.ca/rmurphy/TW_photos.zip